Canon 7086 Series Service Manual - page 279
Chapter 7
7-33
F-7-51
Waste toner can drop on the duplex unit when the process unit is removed.
After mounting the process unit. be sure to slide out the duplex unit and re-
move the waste toner.
7.10.2 Pre-Exposure Lamp
7.10.2.1 Removing the Pre-Exposure Lamp Unit
0010-8819
iR7105 / iR7095 / iR7086
1) Open the front cover.
2) Slide out the process unit.
Cover the drum with A3 paper or the like when you have slid out the process
unit.
3) Disconnect the connector [1], and remove the two screws [2]; then, detach
the preexposure unit [3].
F-7-52
4) Remove the three screws [1], and detach the pre-exposure holder [2]; then,
detach the pre-exposure lamp [3].
F-7-53
F-7-54
7.10.3 Primary Charging Assembly
7.10.3.1 Removing the Primary Charging Assembly
0010-8821
iR7105 / iR7095 / iR7086
1) Open the front cover.
2) Remove the primary charging assembly over [1].
- 1 screw [2]
F-7-55
3) Disconnect the connector [1]; then, while turning the stop lever [2] in the
direction of the arrow, slide out the primary charging assembly [3].
F-7-56
7.10.4 Pre-Transfer Charging Assembly
7.10.4.1 Removing the Pre-Transfer Charging Assembly
0010-8823
iR7105 / iR7095 / iR7086
[1]
[2]
[3]
[4]
[5]
[1]
[2]
[3]
[1]
[2]
[3]
[2]
[1]
[2]
[3]
[1]