Canon 7086 Series Service Manual - page 700
Chapter 18
18-8
7) When a message has appeared to indicate that the system software has been installed, click [OK].
F-18-7
18.2.2 Copying the System Software (SST -> USB)
0011-6752
iR7105 / iR7095 / iR7086
Here, you will be copying the system software from the SST to a USB device.
[Preparatory Work]
Requirements
- PC to which the SST (version 3.21 or later) has been installed
- USB device *
You will not be able to use a security-protected USB device. Be sure to remove the protection before use.
[Copying the System Software]
1) Start up the PC.
2) Connect the USB device to the USB port of the PC.
3) Start up the SST.
*: USB Requirements
Interface
USB 1.1 or higher (USB 2.0 recommended)
Capacity
1 GB or more recommended (A set of system software is in excess of 512 MB.)
Format
FAT (FAT16), FAT32 (It must not be NTFS or HFS.)
single partition (There must not be multiple partitions.)
CONTROL
Registerd Firms
Found Firm
iR7105
iRYYYY
HDFormat
XXxxv0002 >>> Regist
BOOT
XXxxv0103 >>> Regist
USenv0112 >>> With no
SYSTEM
XXxxv0111 >>> Regist
TTS
XXenv0111
OK!
KEY
XXenv0107 >>> Regist
RUI
XXenv0112 >>> Regist
LANGUAGE
XXxxv0100 >>> Regist
BROWSER
XXxxv0102 >>> Regist
DCON
XXxxv0105 >>> Regist
MEAPCONT
XXxxv6102 >>> Regist
G3FAX
TTS
XXenv0111
iRCXXXX
HDFormat
XXxxv0002
KEY
XXxcv0101
XXxpv0101
SDICT
Registered fir mware
F i r m wa r e r e g i s t ra t i o n c o m p l e t e d .
> > > B a t c h R e g i s t ra t i o n R e s u l t s
C l i c k a b u t t o n t o exe c u t e .
CONNECT
CANCEL
EXIT
O K
R e g i s t e r F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
Service Support Tool DLM0 (Ver.3.21E)