Canon 7086 Series Service Manual - page 135
Chapter 2
2-77
F-2-257
14) Mount the relay harness unit [2] to the rear side plate using 2 screws [1].
15) Fit the 2 tie-wraps (w/ lock) [3] of the relay harness in the holes of the rear side plate as shown to fix the relay harness in place.
16) Connect the 2 connectors [4] on both sides of the relay harness unit.
F-2-258
17) Mount the external covers of the paper deck in sequence as follows.
1. Upper over (M4x8, 4 pc.; Be sure to avoid trapping the wire.)
2. Upper front cover (M4x8, 4 pc.; Connect the connector.)
3. Rear cover (M3x8, 2 pc.; M4x8, 5 pc.)
4. Right cover (M4x8, 3 pc.)
18) Slide the paper deck to the left by hand to set it to the host machine.
19) Attach the power supply label [1] to the rear over of the paper deck as shown.
F-2-259
20) Connect the power cable [1] to the power cord base of the heater. Then, connect the other power plug [2] to the AC outlet of the host machine.
21) Fit the stop ring [3].
- RS tightening screw (M4X8; White)[4]
[1]
[2]
[1]