Oceanic ATOM Operating Manual - page 123

123

To view that dive's Log during the Transition Period -

•  Press and release the A button (< 2 seconds) to access the

Preview screen (Fig. 115).

•  Press the S button  to view the Nitrogen data screen.  See

page 84.

•  Press the S button again to view the Oxygen data screen (if a

Nitrox dive).  See page 84.

•  Press the S button again to return to Surface Mode.

•  The unit will revert to Surface Mode after 2 minutes if no

button is pressed.

Log Data will not be stored in the unit's memory until the 10

minute Transition Period on the surface is completed.

Once 10 minutes have elapsed, the Surface Interval time display

colon stop flashing  indicating that the Dive and Transition Period

are completed, and a subsequent descent will be  considered a

new dive.  Operation will revert to the Main Time Display.

AFTER THE TRANSITION PERIOD

Once the Transition Period has ended, Dive Surface Mode (Fig.

116) can be accessed from Main Time Mode by pressing the M

button 5 times and you will then have full access to other dive

computer modes (e.g., Plan, Fly, Sat, Log, Hist, Set, etc.).

•  To activate the Backlight at any time, press the L button.

Fig. 115 - Log Preview

(during Transition Period)

Fig. 116 - Surface Mode

 (after Transition Period)