Oceanic ATOM Operating Manual - page 51

51

SET FO2 50% DEFAULT information includes (Fig. 48):

>  Graphics DFLT and 50

>  Set Point graphic ON (or OFF), flashing.

>  Symbols FO2 and NITROX.

•  Pressing and releasing the S button (< 2 seconds) will toggle

between ON and OFF.

•  Pressing and releasing the A button momentarily (< 2 sec-

onds) will save the setting and/or advance to SET RECEIVER

with the Set Point flashing.

•  Pressing and releasing the A button momentarily and repeat-

edly (< 2 seconds) will step through the other SET D screens.

•  Depressing the A and S buttons simultaneously for 2 seconds

will save the setting and revert back to the SET D screen.

•  Depressing and holding the M button for 2 seconds will revert

to the Surface Mode screen.

•  If no button is pressed during a period of 2 minutes, the unit

will revert to the Surface Mode screen.

Fig. 48 - Set FO2 Default

Refer to page 46 for

a description of FO2

50% DEFAULT.