Oceanic ATOM Operating Manual - page 44

44

Fig. 39 - Wet

(DC Surface Mode)

Fig. 40 - Wet

(Watch Time Mode)

WET CONTACTS

The Wet Contact Dive Mode Activation feature is active any time

WET ACTIVATION is set ON.

The ATOM is configured with contacts that will automatically

activate Dive Mode when the space between the contacts is

bridged by a conductive material (immersed in water) and it

senses a Depth greater than 4 feet (1.2 meters).

The contacts are the pins of the PC Interface Data Port and one

or more of the Push Buttons.

As long as the contacts are bridged on the Surface, the graphic

WET will appear on the DC SURFACE MODE (Fig. 39), MAIN

TIME (Fig. 40), and ALTERNATE TIME displays as an alert the

that the unit is Wet.

Upon removing the bridge between the contacts (drying the

ATOM), the graphic WET will be replaced with the Altitude

graphic SEA (or LEV2 through LEV7) during Dive Surface Mode

or Week Day (MON - SUN) during Main and Alternate Time

Modes.

The ATOM will continue checking for Depth, until a dive is made

or it reverts to the Local Default Time screen after 2 hours.