Oceanic ATOM Operating Manual - page 45

45

DIVE COMPUTER SET MODES

Set Mode Sequence:

Surface Mode > SET D > SET A > SET U > SERIAL No. screen.

Access is gained by simultaneous 2 second presses of the A and

S buttons.

Alarms (Set A) and Utilities (Set U) can also be set/changed using

the PC Settings Upload program.  Dive Data (Set D) entries must

be made using only the push buttons.

SET D GROUP (DIVE DATA)

Set D Sequence:

SET D > FO2 (GAS 1) > FO2 (GAS 2) > FO2 (GAS 3) > FO2

50% Default > Receiver > Digital Gauge

>  The ATOM reverts to the Default Settings when 24 hours

elapse without a dive or after a dive.

>  Depressing the A and S buttons simultaneously for 2 seconds

while in the SURFACE MODE will access SET D identified by

the graphic SETD (Fig. 41).

>  Pressing and releasing the A button momentarily (< 2 sec-

onds) while SET D is displayed will advance to SET FO2

(GAS 1) with the Set Point flashing.

Fig. 41 - Set D

SET D DEFAULT SETTINGS

FO2 GAS1 > AIR

FO2 GAS2 > AIR

FO2 GAS3 > AIR

FO2 50% DEFAULT > ON

RECEIVER  > OFF

DIG GAUGE MODE > OFF