Oceanic ATOM Operating Manual - page 60

60

SET TURN PRESSURE ALARM (for Transmitter 1 only)

Information includes (Fig. 57A/B):

>  Graphic TURN

>  Set Point OFF or a numeric value, flashing.

>  Symbol PSI (or M)

•  Pressing and releasing the S button momentarily (< 2 sec-

onds) will step through the Set Points from OFF to 1,000 to

3,000 PSI (69 to 205 BAR) in 250 PSI (17 BAR) increments.

•  Depressing and holding the S button will scroll through the

Set Points at a rate of 4 Set Points per second until it is

released.

•  Pressing and releasing the A button momentarily (< 2 sec-

onds) will save the setting and/or advance to the SET END

PRESSURE ALARM screen with the Set Point flashing.

•  Pressing and releasing the A button momentarily and repeat-

edly (< 2 seconds each time) will step through the other SET A

screens.

•  Depressing the A and S buttons simultaneously for 2 seconds

will save the setting and revert back to the SET A screen.

•  Depressing and holding the M button for 2 seconds will revert

to the Surface Mode screen.

•  If no button is pressed during a period of 2 minutes, the unit

will revert to the Surface Mode screen.

Fig. 57B - Set Turn Pressure

Alarm (value)

Fig. 57A - Set Turn Pressure

Alarm (OFF)