Oceanic ATOM Operating Manual - page 135

135

Transmitter Battery Installation

•  Lightly lubricate the new Battery Cap O-ring with silicone

grease and install it onto the Battery Cap.  DO NOT roll the

O-ring over the Threads, instead stretch it slightly to work it

down over the slotted end of the Cap into the Groove at the

Base of the Threads  (Fig. 124).

NOTE:  The O-ring must be a genuine Oceanic

part that can be purchased from an Authorized

Oceanic Dealer.  Use of any other O-ring will

void the warranty.

•  Place a new 3 volt, CR2, Lithium Battery (Duracell model DL-

CR2 or equivalent) positive (+) side down into the Battery

Compartment with the negative end facing up/out (Fig. 125).

•  Ensure that the Battery is properly oriented and the Hatch O-

ring is evenly seated around the Battery Hatch.

•  Carefully place the Battery Hatch with Spring into the Hous-

ing and turn clockwise slowly by hand to ensure proper

threading. Apply a coin and tighten until secure.  The outer

surface of the Battery Hatch should be flush with the outer

surface of the Housing (Fig. 126).

Fig. 125 - Transmitter Battery

Orientation

Battery

(+)  ( - )

Fig. 124 - Transmitter O-ring

Installation

Fig. 126 - Transmitter Battery

Hatch Installed