Oceanic ATOM Operating Manual - page 52

52

SET ATOM's RECEIVER information includes (Fig. 49):

>  Graphic RCVR

>  Set Point graphic ON (or OFF), flashing.

•  Pressing and releasing the S button (< 2 seconds) will toggle

between ON and OFF.

•  Pressing and releasing the A button momentarily (< 2 sec-

onds) will save the setting and/or advance to SET DIGITAL

GAUGE with the Set Point flashing.

•  Pressing and releasing the A button momentarily and repeat-

edly (< 2 seconds) will step through the other SET D screens.

•  Depressing the A and S buttons simultaneously for 2 seconds

will save the setting and revert back to the SET D screen.

•  Depressing and holding the M button for 2 seconds will revert

to the Surface Mode screen.

•  If no button is pressed during a period of 2 minutes, the unit

will revert to the Surface Mode screen.

NOTE:  When set OFF, the Receiver is disabled

and does not activate to search for Pressure

signals or Transmitter Battery Status.  Displays

and calculations relating to Tank Pressure will

not be made until the Receiver is set ON.

Fig. 49 - Set Receiver