Oceanic ATOM Operating Manual - page 18

18

To check the condition of the ATOM or a Transmitter's Battery,

depress the S button for 2 seconds while in Dive Computer

Surface Mode then release it.

•  As the button is depressed, the ATOM's Receiver will acti-

vate.

•  2 seconds later, the ATOM (Watch)'s Battery status will be

displayed for 3 seconds (Fig. 5), then -

•  if active and linked, Transmitter 1's Battery status will be

displayed for 3 seconds, then -

•   if active and linked, Transmitter 2's Battery status will be

displayed for 3 seconds (Fig. 6A), then -

 •  if active and linked, Transmitter 3's Battery status will be

displayed for 3 seconds, then -

•  the display will then revert to Surface Mode.

•  If a Transmitter is not active and linked, the message

NotAvAil (not available) will be displayed (Fig. 6B).

Tank Pressure (described later) will also appear on the active

Transmitters Battery Status displays.

Fig. 5 - Battery Status (Good)

Fig. 6B - Transmitter 3 Status

(Not Available)

Fig. 6A - Transmitter 2 Battery

Status (Low)