Oceanic ATOM Operating Manual - page 137

137

TRANSMITTER INSTALLATION on REGULATOR

To install the Transmitter on the Regulator First Stage:

• Remove the existing Pressure Gauge and High Pressure Hose,

or the High Pressure Port Plug from the Port marked HP using

the proper size Hex Key.

• Lightly lubricate the O-ring and Threads of the Transmitter

fitting with a halocarbon based lubricant such as Christo-Lube

MCG111 (provided in Oceanic Battery Kits).

• Thread the Transmitter clockwise by hand into the Regulator's

HP Port (Fig. 127) and tighten until secure with a 5/8" open-

end wrench.

• Attach the Regulator First Stage to a full Scuba Tank and

pressurize by slowly opening the Tank Valve, listening for any

indication of air leaking around the Fitting.

•  If air leakage is present, DO NOT use, take the complete

Regulator Assembly to an Authorized Oceanic dealer for

inspection and service.

TRANSMITTER COMPATIBILITY WITH NITROX

When packaged and shipped from the factory, Oceanic ATOM

Transmitters are rated for use with compressed Air and/or

nitrogen-oxygen (Nitrox) breathing gas mixtures containing up to

99% O2 by volume and with 100% O2.

Fig. 127 -Threading

Transmitter into Regulator