Oceanic ATOM Operating Manual - page 70

70

SET TRANSMITTER 1 LINK CODE information includes (Fig. 67):

>  Graphics TID1, and ON (or OFF) flashing.

>  Set Point (numerical Link Code/transmitter's serial number).

•  Pressing and releasing the S button momentarily (< 2 seconds) will toggle between ON

and OFF.

•  Pressing and releasing the A button momentarily (< 2 seconds) will accept the ON/OFF

selection.

•  If OFF is selected, SET TID2 and TID3 will be bypassed and the operation reverts to the

SET U screen.

•  If ON is selected, the first (left) digit of the LINK CODE will flash.

•  Pressing and releasing the S button momentarily and repeatedly (< 2 seconds each

time) will increase the First Digit from 0 to 9 in increments of 1.

•  Depressing and holding the S button will scroll through the Set

Points at a rate of 4 per second.

•  Pressing and releasing the A button (< 2 seconds) will accept

the First Digit of the Code and/or advance to the Second Digit

which will be flashing.

•  Pressing and releasing the S button shall increase the Second

Digit from 0 to 9 in increments of 1.

•  Depressing and holding the S button will scroll through the Set

Points at a rate of 4 per second.

•  Pressing and releasing the A button (< 2 seconds) will accept

the Second Digit of the Code and/or advance to the Third Digit

which will be flashing.

Fig. 67 - Set TID1