Oceanic ATOM Operating Manual - page 66
66
SET SAFETY STOP information includes (Fig. 63):
> Graphic SAFE
> Safety Stop Time Set Point, flashing.
> Symbols STOP and TIME.
> Safety Stop Depth Set Point and symbol FT (or M).
• Pressing and releasing the S button momentarily (< 2 seconds
each time) will step through the Set Points of OFF, 3:00, and
5:00 (minutes:seconds).
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the Stop Time setting and the Stop Depth Set
Point will flash, or if Stop Time is set OFF advance to the SET
CONSERVATIVE FACTOR screen with the Set Point flashing.
• Pressing and releasing the S button momentarily (< 2 seconds
each time) will step through the Set Points of 10, 15, and 20
FT (or 3, 4.5, and 6 M).
• Pressing and releasing the A button momentarily (< 2 sec) will
save the Safety Stop settings and/or advance to the SET
CONSERVATIVE FACTOR screen with the Set Point flashing.
• Pressing the A button momentarily and repeatedly (< 2
seconds) will step through the other SET U screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the settings and revert back to the SET U screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 63 - Set Safety Stop
Refer to page 100
for a description of
the No Decompres-
sion dive mode
Safety Stop feature.