Riverbed Steelhead CX Series Installation Manual - page 16
12
Rack Installation Guide
Installing Steelhead CX, DX, EX, Granite, and Cascade Systems
Mounting Desktop CX Systems in a Rack
7.
Attach the two-prong power cord connector to the tray insert and insert the power cord.
The connector consists of an upper and lower piece. Use two screws to attach the lower piece to the
tray insert, insert the power cord into the connector, and use two more screws to secure the upper piece
to the lower piece.
Figure 1-8. Attaching Power Cord Connector
8.
Attach the power supply to the tray insert.
It attaches with four screws—two on each side of the power supply.
Figure 1-9. Attaching Power Supply
9.
Slide each power supply tray into the power supply platform until the power cord connects with the
appliance.
The two prongs serve as guides to align the cord with the appliance and fit into holes on the rear of the
appliance.
Figure 1-10. Inserting Power Supply Trays
10.
Tighten the thumb screws.