Riverbed Steelhead CX Series Installation Manual - page 28
24
Rack Installation Guide
Installing Steelhead CX, DX, EX, Granite, and Cascade Systems
Working With 1U and 2U CX, DX, EX, Granite, and Cascade
4.
Pull the release tabs on both of the inner rails and push the unit all the way into the rack.
Figure 1-29. Sliding the System into the Rack and Pulling the Inner Rail Release Tab
Operating the Rails
To operate the rails, follow these guidelines:
To pull the system from the rack without removing it, pull it until it stops.
To remove the system from the rack, push the release tab and remove the system.
To push the system back into the rack, use the inner rail release tab pictured in
“Sliding the System into
the Rack and Pulling the Inner Rail Release Tab” on page 24
.
Caution:
Use caution when the system is mounted in a rack and the outer rails are extended; do not place objects or
additional weight on the system.