Riverbed Steelhead CX Series Installation Manual - page 33
of
50
Rack Installation Guide
29
Mounting 1U Steelhead xx50 Systems in a Rack
Installing Steelhead xx50 and Whitewater xx10 Systems
3.
Slide the ball bearing retainer on the inside of the outer rail to the foremost position.
Figure 2-5. Sliding the Ball Bearing Retainer to the Foremost Position
Note:
The ball bearing retainer must be pushed forward and placed in the front position before attaching a chassis to
the rack.
4.
Slide the inner rails into the outer rails, pushing the system into the rack.
Figure 2-6. Sliding the System into the Rack