Riverbed Steelhead CX Series Installation Manual - page 25
Rack Installation Guide
21
Working With 1U and 2U CX, DX, EX, Granite, and Cascade Systems Using RMK-006 Rails
Installing Steelhead CX, DX, EX,
To adjust the length of the rails
1.
Remove outer rails from the chassis and the inner rail.
Push the white release button and pull the outer rail away from the chassis.
Figure 1-23. Detaching the Outer Rails from the Chassis
2.
Turn over the outer rail and remove the three screws that secure the depth bracket.
Adjust the position of the ball bearing slider and the oval access area to access these screws.
3.
Move the bracket to the appropriate position for the required length and secure with three screws.
You do not need to remove the rear brackets to adjust the rail sizes.
For the short position, align the left screw hole on the bracket with the hole third from the left on the
outer rail and secure with the three screws.
Figure 1-24. Short Bracket Position