Riverbed Steelhead CX Series Installation Manual - page 27
of
50
Rack Installation Guide
23
Working With 1U and 2U CX, DX, EX, Granite, and Cascade Systems Using RMK-006 Rails
Installing Steelhead CX, DX, EX,
The screw set is included in the appliance accessory kit.
Figure 1-27. Attaching the Outer Rails to the Rack
2.
Verify the ball bearing retainer is locked in the forward position of the outer rails.
Important:
The ball bearing retainer on the outer rail must be returned to the foremost position to connect with the inner
rail on the chassis. The bearings might fall off if the ball bearing retainer is not pushed forward.
Figure 1-28. Ensuring the Ball Bearing Retainer is Locked
3.
With two people lifting the system, gently slide the inner rails into the outer rails until you reach a hard
stop.