Riverbed Steelhead CX Series Installation Manual - page 30
26
Rack Installation Guide
Installing Steelhead xx50 and Whitewater xx10 Systems
Mounting 1U Steelhead xx50 Systems in a Rack
2.
To install the mounting brackets, use the included screw kit to secure the brackets onto the sides of the
chassis (at the front of the system) using three screws on each side.
Figure 2-1. Installing Brackets to the Desktop System
3.
To mount the brackets to the posts, slide the system into the rack until the front is flush against the rack
posts. Install the included washer and screw in the center hole of the bracket. The Series x50 must be
installed in a front mount.
4.
Insert and tighten the rack post screws on each side of the system.
Mounting 1U Steelhead xx50 Systems in a Rack
This section describes how to install Steelhead xx50 systems in a four-post or two-post rack. It includes the
following topics:
“To open the bezel on xx50 systems” on page 27
“Mounting 1U Steelhead xx50 Systems Using RMK-002A Rails” on page 27
“Mounting 1U Steelhead xx50 Systems in a Four-Post Rack” on page 30
“Center Mounting 1U Steelhead xx50 Systems in a Two-Post Rack” on page 32