Riverbed Steelhead CX Series Installation Manual - page 31
of
50
Rack Installation Guide
27
Mounting 1U Steelhead xx50 Systems in a Rack
Installing Steelhead xx50 and Whitewater xx10 Systems
To open the bezel on xx50 systems
To open the bezel firmly press in the buttons on each side of the bezel and slide it towards you. The
bezel remains attached to the system on hinges.
Figure 2-2. Opening the Bezel on Series xx50 Systems
Mounting 1U Steelhead xx50 Systems Using RMK-002A Rails
This section describes how to mount the Steelhead xx50 system to a four-post rack using rack mount kit
RMK-002A. The RMK-002A rails are modified rails for 1U xx50 systems.
1.
To detach the outer rails, press the release latch and pull the outer rails away from the system.
Figure 2-3. Using the Release Latch to Detach the Outer Rails