Riverbed Steelhead CX Series Installation Manual - page 40
of
50
36
Rack Installation Guide
Installing Steelhead xx50 and Whitewater xx10 SystemsMounting 3U Steelhead xx50, WWA-x10, and WWA-xx10 Systems in a Rack
Important:
In some environments the bracket screws cannot be reached after the rails have been installed. In this case
the length of the outer rails should be adjusted and secured before mounting the outer rails into the rack.
Figure 2-17. Adjusting Length of the Outer Rails
Note:
The screws on the front bracket are pre-adjusted, do not loosen those screws.
To install the outer rails to a rack
After you have detached the outer rails from the inner rails on the chassis and adjusted the length of the
outer rails to fit your rack posts, you are ready to install the outer rail assemblies to the rack.