Riverbed Steelhead CX Series Installation Manual - page 42
38
Rack Installation Guide
Installing Steelhead xx50 and Whitewater xx10 SystemsMounting 3U Steelhead xx50, WWA-x10, and WWA-xx10 Systems in a Rack
2.
When the system has reached a hard stop, pull the release tabs on both of the inner rails and push the
unit all the way into the rack.
Figure 2-19. Sliding the System into the Rack and Pulling the Inner Rail Release Tab
To operate the rails
1.
To pull out the system from the rack without removing it, pull it until it stops.
2.
To push the system back into the rack, use the inner rail release tab pictured in the previous illustration
“Sliding the System into the Rack and Pulling the Inner Rail Release Tab”
.
3.
To remove the system from the rack, pull until the outer rail release tab pictured in
“Releasing the Outer
Rail” on page 35
, is visible.
Caution:
Use caution when the system is mounted in a rack and the outer rails are extended, do not place objects or
additional weight on the system.