Riverbed Steelhead CX Series Installation Manual - page 29
Rack Installation Guide
25
CHAPTER 2
Installing Steelhead xx50 and
Whitewater xx10 Systems
This chapter describes how to install Series x50, xx50, WWA-x10, and WWA-xx10 in a standard Telco-type
rack. It includes the following sections:
“Mounting Desktop Steelhead x50 Systems in a Rack” on page 25
“Mounting 1U Steelhead xx50 Systems in a Rack” on page 26
“Mounting 3U Steelhead xx50, WWA-x10, and WWA-xx10 Systems in a Rack” on page 34
Important:
All 3U systems must be mounted to a four-post rack; they cannot be mounted to a two-post rack.
Mounting Desktop Steelhead x50 Systems in a Rack
This section describes how to install Steelhead x50 systems in a rack.
Important:
Steelhead x50 systems are designed for side-to-side airflow. If you install these systems in a rack, do not
place objects on the sides of the system; it restricts airflow and can damage the system.
To install mounting brackets to the system
1.
Carefully lift the system out of the shipping carton.