Riverbed Steelhead CX Series Installation Manual - page 19
of
50
Rack Installation Guide
15
Mounting 1U and 2U CX, DX, EX, Granite, and Cascade Systems Using RMK-002A Rails Installing Steelhead CX, DX, EX, Granite,
2.
Install the outer rails to the rack posts.
Note:
The RMK-002A rails can accommodate a 22-inch to 32-inch deep rack and a maximum device weight of 81 lb (40
kg).
Figure 1-13. Attaching the Outer Rails to the Rack
3.
Slide the ball bearing retainer on the inside of the outer rail to the foremost position.
Important:
The ball bearing retainer on the outer rail must be returned to the foremost position to connect with the inner
rail on the chassis. The bearings might fall off if the ball bearing retainer is not pushed forward.
Figure 1-14. Sliding the Ball Bearing Retainer to the Foremost Position