Riverbed Steelhead CX Series Installation Manual - Systems In A Rack
34
Rack Installation Guide
Installing Steelhead xx50 and Whitewater xx10 SystemsMounting 3U Steelhead xx50, WWA-x10, and WWA-xx10 Systems in a Rack
4.
Attach the first bracket to the chassis with the three included screws.
Figure 2-14. Attaching Two-Post Center-Mount Brackets
5.
Slide the second bracket onto the pegs of the first bracket by placing the second bracket over the first
bracket at the widest opening then slide towards the narrower part to secure.
Figure 2-15. Attaching Second Bracket to First Bracket
6.
Repeat steps 4 and 5 on the other side of the chassis.
7.
Center-mount the system on a two-post rack.
Mounting 3U Steelhead xx50, WWA-x10, and WWA-xx10
Systems in a Rack
The Steelhead xx50, WWA-x10, and WWA-xx10 ship with rails pre-installed to the chassis for mounting to
a four-post rack. This section describes how to install the system in a four-post rack.