Riverbed Steelhead CX Series Installation Manual - Systems Using Rmk-006
Rack Installation Guide
19
Working With 1U and 2U CX, DX, EX, Granite, and Cascade Systems Using RMK-006 Rails
Installing Steelhead CX, DX, EX,
Working With 1U and 2U CX, DX, EX, Granite, and Cascade
Systems Using RMK-006
Rails
You can mount 1U and 2U Steelhead CX, EX, DX appliances, Cascade xx60 systems, and the Granite Core
2000 appliance using the RMK-006 rails. These rails are also known as King Slide rails.
The RMK-006 rails are preset for racks with depths of 24-7/8
inches to 28-9/16 inches (632 mm - 726 mm).
You can adjust the size of these rails to fit your rack.
This section describes:
“Setting Up the Rails” on page 19
“Mounting the System” on page 22
“Operating the Rails” on page 24
Setting Up the Rails
To set up the rails, detach the inner rails from the outer rails and attach the inner rails to the appliance.
To detach the inner rails from the outer rails
Push the white release button and pull out the inner rail.
Figure 1-20. Releasing the Inner Rail from the Outer Rail
To attach the inner rail to the chassis
Install the inner rails to the sides of the chassis using the included M4x4 screws.