Riverbed Steelhead CX Series Installation Manual - page 34
30
Rack Installation Guide
Installing Steelhead xx50 and Whitewater xx10 Systems
Mounting 1U Steelhead xx50 Systems in a Rack
Mounting 1U Steelhead xx50 Systems in a Four-Post Rack
Steelhead xx50 systems ship with rails pre-installed to the chassis for mounting to a four-post rack. This
section describes how to mount the Steelhead xx50 system to a four-post rack.
To mount the Steelhead xx50 to a four-post rack
1.
To detach the outer rails, slide the outer rail to the end of the system and engage the release latches. The
right release latch must be pushed down and the left release latch must be pushed up.
2.
Pull the outer rail completely off the system.
Figure 2-7. Detaching the Outer Rails
3.
If needed, attach the brackets to the outer rails with the included screw set.
Figure 2-8. Attaching Brackets to Outer Rails
4.
To adjust the length of the outer rails to fit the distance between your rack posts, loosen the screws on
the longer rear bracket of the outer rails. You can tighten and secure the bracket screws after you have
affixed the outer rails to the rack posts.