Riverbed Steelhead CX Series Installation Manual - Overview
Rack Installation Guide
1
Preface
This preface describes the prerequisite requirements for installing Riverbed systems to a Telco-type rack.
The preface includes the following sections:
“Overview” on page 1
“Rack Installation Safety Guidelines” on page 2
“Required Tools and Equipment” on page 3
“Safety Guidelines” on page 4
“Additional Resources” on page 4
“Contacting Riverbed” on page 5
Important:
For rack installation instructions describing 560 and 760 systems, see the documentation enclosed with these
products.
Important:
All 2U and 3U systems must be mounted to a four-post rack; they cannot be mounted to a two-post rack.
Overview
Depending on your order, some systems require that the inner rails be attached to the chassis before they
can be installed in a rack.
Square Post-Hole Adaptor
Rack cabinets can have square or circular holes in the vertical posts. If necessary, to accommodate standard
screws you can convert the square post-holes to circular holes using the included square post-hole adaptors.