Riverbed Steelhead CX Series Installation Manual - page 41
of
50
Rack Installation Guide
37
Mounting 3U Steelhead xx50, WWA-x10, and WWA-xx10 Systems in a Rack
Installing Steelhead xx50 and Whitewater xx10
1.
Install the outer rails to the rack posts with the included screw set.
Figure 2-18. Attaching the Outer Rails to the Rack
Important:
The sliding part of the outer rails should not be extended when inserting or removing the system.
To mount the system on a rack
1.
With two people lifting the system, gently slide the inner rails into the outer rails until you get to a hard
stop.
Important:
The inner and outer rails must meet precisely and the system must be held level to join the rails.
The sliding part of outer rails should not be extended when joining the inner and outer rails
.