Riverbed Steelhead CX Series Installation Manual - page 48
44
Rack Installation Guide
Installing Whitewater xx30 Systems
Installing Whitewater Expansion Shelves in a Rack
–
Tighten the two clamping screws located along the inside of the rear section of the rack bracket.
Figure 3-3. Securing Brackets to the Rail
3.
Install the enclosure into the rack.
–
Lift the enclosure and align it with the rack rails.
–
Carefully insert the chassis slides into the rack rails and push fully in.
–
Tighten the mounting screws in the rear rack bracket.
–
Remove the enclosure until it reaches the hard stops (approximately 400mm) and tighten the
mounting screws in the front rack bracket.
–
Return the enclosure to the home position.
For More Information
See the Whitewater Cloud Storage Appliance Installation Guide for more information and next steps.
See the Whitewater xx30 Series Expansion Shelf Hardware Owner’s Manual for more details about the hardware
and technical specifications.