Webasto Thermo Top C Installation Instructions Manual - Honda Civic
18
Honda Civic
Fuel Connection
CAUTION!
Open the vehicle's fuel tank cap, ventilate the tank and then re-close the tank lock.
Catch any fuel running off with an appropriate container.
Install fuel line and metering-pump wiring harness so that they are protected against stone impact.
Unless specified otherwise, always fasten using cable ties.
Mount the fuel line and wiring harness with rub protection on sharp edges.
WARNING!
The fuel line and wiring harness are routed to the metering pump in as shown in the wiring harness
routing diagram.
2
Mecanyl fuel line
3
Hose section, 10 mm dia. hose clamp [2x]
1
Cable tie
Con-
nection on
heater unit
Route Mecanyl fuel line and wiring harness of
metering pump together along original
vehicle fuel lines to installation location of
metering pump. Pull both into corrugated
tube on underbody at position 2.
1
Metering pump
Installing
lines
Ensure proper installation position of metering
pump, see "Installation Instructions“.
Installation location on left behind vehicle fuel
tank!
Fuel line from heater unit on pressure side of
metering pump [side with connector].
1
Noise isolation mounts, flanged nut M6 [2x]
2
Rubber-coated pipe clamp
3
Hose section, 10 mm dia. hose clamp [2x]
4
Corrugated tube
5
Wiring harness with connector
6
Original vehicle bolt, large diameter
washer between perforated bracket 7 and
vehicle
Installation
location of
metering
pump
30
1
2
3
31
2
1
32
4
1
2
7
6
3
5
i