Webasto Thermo Top C Installation Instructions Manual - page 10
10
Thermo Top C
3 Heater Mounting
3.1 Recommended Locations
Refer to Figure 10 for the location of heater
connections and dimensions, this will aid in
determining the best mounting site.
CAUTION
The heater must not be installed in the
immediate vicinity of hot vehicle parts or
in the direct splash-water area of the
wheels.
ATTENTION
Ensure to maintain sufficient clearance
between the heater and moving vehicle
components under all driving conditions,
i.e. vehicle suspension, engine, etc.
Consider how exposure to extreme
elements will affect heater operation, i.e.
rocks, mud, snow, etc.
Recommended heater locations: Engine Compartment, Front Fenders (above splash shields), frame rail, etc...
ATTENTION
The coolant pump on the Webasto heater
is not of the self-priming type. To ensure
automatic venting of the heater and
circulation pump mount the heater in the
lowest protected area possible.
CAUTION
The opening of the coolant connection
pipes must never point in a downward
direction in any installation position.
Figure 11 identifies the correct mounting
positions for the proper operation of the
Webasto heater.
3.1.1 Sample Heater Installation (
Chrysler 300 C
)
CAUTION
Sheet metal screws must never be used to secure
heater mounting brackets to the vehicle.
ATTENTION
• The heater mounting brackets must have a minimum
of three anchor points.
• Remove burs and sharp edges from heater mounting
bracket after modification.
Cut supplied mounting bracket as shown in figure 12.
Bend mounting bracket “ears” inward 90° as shown.
– (1) Heater mounting bracket (Front View)
– (2) Heater mounting bracket (Side View)
Fig. 10
90°
90°
Fig. 11
1
Fig. 12
90°
90°
2