Webasto Thermo Top C Installation Instructions Manual - Mercedes Benz W 203
5
(
1
) Heater unit
Heater Unit
Installation
Location
2
1
Warning!
- Remove the passenger compartment filter in the engine compartment
- Disconnect the battery and remove it!
- Remove the battery base plate.
- Let off
pressure in the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Open the tank cap, ventilate the tank.
- Close the tank cap again.
- Remove the right front wheel.
- Remove front right headlight.
- Remove the cover strip for the towing hook on the front right bumper.
- Remove the underride protection on the right side of the vehicle.
- Remove the rocker panel strip on the front passenger side and the front and back of the driver’s
side.
- Remove the A-pillar panel in the driver’s side and passenger side footwell.
- Remove the lower dashboard panel on the passenger side, loosen on the driver’s side
- Remove the cover of the fuse box on the driver’s side of the dash board.
- Remove the gas pedal.
- Remove the floor carpet on the driver and passenger side
- Remove the air channels for the rear seat heating in the driver’s side and passenger side footwell.
- Remove the floor mat in the trunk.
- Remove the cover plate for the cable duct behind the rear seat bench.
- Remove the side trunk panelling on the driver’s side.
- Loosen the fuse and relay box (SAM) in the trunk.
- Remove the antenna cable from the cable harness (is not required).
Pre-
liminary