Webasto Thermo Top C Installation Instructions Manual - Vw Fox
5
VW Fox
Heater Unit Installation Location
1 Heater unit
Installation
location
1
1
Preliminary Work
WARNING!
- Disconnect the battery.
- Let off
pressure in the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Remove the engine cover.
- Remove the windshield wiper arms.
- Remove the wiper assembly.
- Remove the cooling water reservoir cover
- Remove the motor controller unit mounting
- Remove the silencer mat from the engine compartment separating wall.
- Remove the water reservoir separating panel to the engine compartment.
- Open the tank cap, ventilate the tank.
- Close the tank cap again.
- Loosen the right and left wheel-house panel.
- Remove the underride protection.
- Remove the bumper.
- Remove the right underbody panel.
- Lift up the rear seat bench.
- Open the tank mounting service lid
- Remove tank mounting according to manufacturer's instructions.
- Remove the glove compartment (only for Thermo Call).
- Remove the lower dashboard panel on the driver’s side.
- Loosen the central electrics.
- Remove air conditioning control according to the manufacturer's instructions (only for Climatronic
systems).
- Please remove page 25 “Operating instructions for the end customer” and add this to the operating
instructions.