Mahr Digimar 817 CLM Operating Instructions Manual - page 105
105
Mahr GmbH • Digimar 817 CLM
Procedure is the same as „Create a new measuring
program“.
7.5
Print a measuring program
The complete program is printed out together with
the program head. The adjustment of the printer is
detailed in section „6.13 Data and printer“ and „5.3
Printing measured values“.
7.4
Change an existing measuring
program
Changes to a measuring program are often necessary,
due to perhaps a change in a technical drawing
(different tolerance, nominal dimension...) or there has
been a review of the teach-in program. An existing
measuring program can be used as a basis for further
programs with similar parts.
Select the measuring program and change or add
improvements in the appropriate menu.
Procedure is the same as „Create a new measuring
program“.
1. <-_______
2. Learn programming (teach - in)
3. Create new program
4. Change existing program
5. Print out current program
6. UCL / LCL computation (measured values)
7. UCL / LCL computation (tolerances)
8. Menu program file management
9. Menu data file management
10.Program STARTStart.
Load program
PRG1
09:57
04/Sep/06
755
TEST1
09:59
04/Sep/06
1175
TEST5
10:18
04/Sep/06
587
Bytes free
: 60457
1. <-_______
2. Learn programming (teach - in)
3. Create new program
4. Change existing program
5. Print out current program
6. UCL / LCL computation (measured values)
7. UCL / LCL computation (tolerances)
8. Menu program file management
9. Menu data file management
10.Program STARTStart.
Load program
PRG1
09:57
04/Sep/06
755
TEST1
09:59
04/Sep/06
1175
TEST5
10:18
04/Sep/06
587
Bytes free
: 63001