Mahr Digimar 817 CLM Operating Instructions Manual - page 57

57

Mahr GmbH • Digimar 817 CLM

Before the characteristics can be determined the 2D mode must be

activated.

In the top right hand corner of the display will appear the 2D symbol

Afterwards, all characteristics that are measured in the 2D mode will

be marked with 2D in the display.

Tilting angle

Measuring a workpiece two-dimensionally requires that the workpiece

be tilted by a known angle. If not specified otherwise, this angle should

be exactly 90°. Angles other than 90° can be either entered via the

keypad or measured directly with an incremental probe.

Note: The more accurate the given tolerance is for the measuring

values, thus the tilting angle must also be more accurate.

Tilting the workpiece

The workpiece will be tilted from one axis to another.

In the display will appear the axis in the top right hand corner of the

display either (X) or (Z).

All the characteristics in both axis must be measured in the exactly the

same sequence.

After a minimum of 2 characteristics (bore/shaft) in both axis has been

measured the operator can automatically select in the menu the

computation functions.

Description / Sequence

Symbols / Pictures

a

a

z

x

Z

X

Z-Achse

X

Z