Mahr Digimar 817 CLM Operating Instructions Manual - page 61

61

Mahr GmbH • Digimar 817 CLM

Description / Sequence

Symbols / Pictures

–

Press „CE“ to delete all data

–

Press the 2D key

Select:

-

Manually enter the tilting angle

-

Calculate tilting angle

-

Active 2D

-

Tilt the workpiece

Description / Sequence

Symbols / Pictures

4.5.4

Determine the distance and angle of 3

elements

The distance between 3 elements (e.g. bores) that are not located one

above the other and the angle and the direct distances are to be

determined. The angle is always put into the characteristic, whose

number is in the middle of the three numbers. The origin of the angle is

therefore lies in the center second characteristic.

The operator can select between the internal and the external angles,

as well as the different distances.

CE

2D

a

a

z

x

2D

ON

–

Select the bore hole.

If several bore holes are to be measured select the characteristics

using the arrow keys and adopt them using the characteristic A

and B.

The cursor shows the selected characteristic.

When there are 2 characteristics they will be automatically adopted as

follows: A = 1 B = 2

–

Confirm

By the evaluation of an angle the specification of the angle will

first appear and then the distance (hypotenuse).

a

2

1

b

3

g