Mahr Digimar 817 CLM Operating Instructions Manual - page 46
Manual is about: quick height
of
152
46
Mahr GmbH • Digimar 817 CLM
4.2.7 Expanding the measuring range
–
Basis-zero point, base plate
–
Use either a gage block or a predetermined workpiece that is
larger
than 180 mm.
–
The probe moves downwards and contacts the gage block or
workpiece.
–
Loosen the clamping screw and turn the probe holder around
180°.
Then tighten the clamping
screw back into position.
–
The probe moves downwards and contacts the gage block or
workpiece.
Description / Sequence
Symbols / Pictures
0