Mahr Digimar 817 CLM Operating Instructions Manual - page 75
75
Mahr GmbH • Digimar 817 CLM
4.8.3 AUTO
Standard settings - select further AUTO functions
4.8.4 Automatically setting the zero point
By using the symbol AUTO zero point yon can automatically set the
previous measured result to zero, thus all following characteristics will
referred to this future zero point.
If the AUTO zero point function key is active, it will remain so until
AUTO key has been pressed.
Procedure:
–
Press the function key AUTO (1 x )
–
Contact the plane F1 from above
–
Contact the plane F2 from above
Results: Dimension16.000 in reference to plane F1
The previous characteristic will automatically be set to zero
Further measurements:
–
Contact the plane F3 from above
Results: Dimension 12.999 in reference to plane F2
–
Contact the plane F4 from above
Results: Dimension 21.001 in reference to plane F3
Description / Sequence
Symbols / Pictures
AUTO
AUTO
AUTO
01
36
28
16
10
26
39
60
F6
F5
F4
F3
F2
F1
Nut