Mahr Digimar 817 CLM Operating Instructions Manual - page 64
64
Mahr GmbH • Digimar 817 CLM
4.5.5
Index circle / Best fit circle
The circle diameter of an index circle consisting of
n bores or shaft
centers are to be determined using the Gaussian method of the least
squares. The circle / shaft center and the circle diameter consists of a
minimum of 3 and a maximum 50 bores or shafts, which the 817 CLM
can calculate.
–
Press „CE“ to delete all data
–
Press the 2D key
–
Active 2D
–
Measure bores 1-3 in the Z-axis
At first the display indicates the Z values;
and subsequently the diameter
–
Tilt the workpiece (The workpiece will be arithmetically aligned at
90°)
–
Measure bores 1 – 3 in exactly the same sequence as with the
X-axis
At first the display indicates the Z values;
and subsequently the X values
–
Tilt the workpiece back into the original position
–
Index circle function
Description / Sequence
Symbols / Pictures
z
x
2D
2D
ON
CE
z
x
X
Z
ø