Mahr Digimar 817 CLM Operating Instructions Manual - page 40
40
Mahr GmbH • Digimar 817 CLM
4.2.1 Set the zero point on the base plate
–
Press the zero point key on the keypad
–
Press the function „Zero point on the base plate“
–
The probe travels automatically to the base plate, the zero
point is set
4.2
Zero points
•
The workpiece zero point can be set only on an already determined characteristic
–
Basic-zero point, base plate .....................................................................................
–
Workpiece zero point 01 .............................................................
–
Workpiece zero point 02 ...........................................................................................
–
Change between set zero points ................................................
–
Preset - alternative zero point ...................................................................................
–
Zero point 03, when zero points 01 and 02 are already set .......
0
01
02
02
01
PR
0
Description / Sequence
Symbols / Pictures
0
0
03