Mahr Digimar 817 CLM Operating Instructions Manual - page 62
Manual is about: quick height
of
152
62
Mahr GmbH • Digimar 817 CLM
–
Tilt the workpiece
(The workpiece will be arithmetically aligned at 90°)
–
Measure the bore holes 1-3 in exactly the same sequence as with
the X-axis
–
Tilt the workpiece
–
Active the „distance and angle between 3 elements “
Description / Sequence
Symbols / Pictures
z
x
a
2D
ON
z
x
–
Select a bore hole
If several bore holes are to be measured select the characteristics
using the arrow keys and adopt them using the characteristic A, B
and C.
When there are 3 characteristics they will be automatically
adopted
as follows:
A = 1 B = 2 C = 3
The cursor shows the selected characteristic.
–
Or manually enter the tilting angle (standard is 90°)
–
Press 2D ON
–
Measure bore holes 1 - 3 in the Z-axis