Mahr Digimar 817 CLM Operating Instructions Manual - page 30
30
Mahr GmbH • Digimar 817 CLM
3.1.4
Measuring a shaft
–
Position the probe below the shaft (eccentrically)
–
Press key to start the measuring procedure
–
The probe will automatically travel upwards and make contact
from below
–
Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
–
Acceptance of the reversal point will be confirmed by an acoustic
signal (beep)
–
Position the probe above the shaft (eccentrically).
–
Press the function key „Contacting a shaft from above“
–
The probe will automatically travel downwards and make contact
–
Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
–
Acceptance of the reversal point will be confirmed by an acoustic
signal (beep) and the results (center and diameter) will appear in
the display.
Description / Sequence
Symbols / Pictures