Mahr Digimar 817 CLM Operating Instructions Manual - page 29
29
Mahr GmbH • Digimar 817 CLM
3.1.3
Measuring a bore
–
Position the probe in the bore (not in the center / eccentrically)
–
Press key to start the measuring procedure
–
The probe will automatically travel upwards; the bore is contacted
from below
–
Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
–
Acceptance of the reversal point will be confirmed by an acoustic
signal (beep)
–
The probe will automatically travel downwards; the bore is
contacted from above
–
Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
–
Acceptance of the reversal point will be confirmed by an acoustic
signal and the results (center and diameter) will appear in the
display
Description / Sequence
Symbols / Pictures