Mahr Digimar 817 CLM Operating Instructions Manual - page 143
143
Mahr GmbH • Digimar 817 CLM
Description / Sequence
Symbols / Pictures
If batteries are fully discharged, completely recharging them takes
approximately 5 hours. The charging device can be connected for a
longer period without any risk, since an intelligent switching circuit
prevents overcharging. The batteries can be charged even if the height
measuring instrument is switched off.
Exchanging the batteries
–
Separate the charging device from the height measuring instrument
–
Remove the battery cover, by unscrewing the 2 knurled thumb
screws, ill. 1
–
Loosen the clip for the RJ-plug and carefully pull out, ill. 2
–
Remove the battery pack out off the retaining spring (clips), ill. 3
–
Press the new battery pack into the retaining spring and reconnect
the plug to the battery pack, ill. 4
–
Replace the battery cover and insert and tighten the knurled thumb
screws
–
Attach the new battery pack to the mains adapter and charger for a
min. 5 hours.
Attention
Please only use the specified battery pack!
1
2
3
4