Mahr Digimar 817 CLM Operating Instructions Manual - page 24
24
Mahr GmbH • Digimar 817 CLM
Enter the traverse path
Display only the diameter
Display a perpendicularity graphic (curve)
Accept the maximum value
Display the diameter
Error character number Z
Active 2D
Quit system
Taper measurement
Characteristic
Accept straightness value
Accept perpendicularity value
Display a straightness graphic (curve)
Accept the minimum value
Bar graph
Error character number X
Deactivate 2D
Change the production data
Taper probe
1.3.5.3 Symbols - display
Bore from above
Bore from below
Shaft from below
Shaft from above
Bore
Shaft
Distance, bar
Distance
Contacting from above
Contacting from below
Symmetry
Position
Min Max
Distance, groove
Internal angle
Perpendicularity
Display diameter
External angle
Taper
Index circle
Coordinate
Straightness
Distance 2D
M =
M =
M =
MIN
Z
M =
Ø
M =
MAX
Ø
?
z
?
x
2D
ON
2D
OFF
A
C
B