Mahr Digimar 817 CLM Operating Instructions Manual - page 26

26

Mahr GmbH • Digimar 817 CLM

2.3

Setting the reference point

The measuring carriage moves automatically to the reference point

(reference point height ca. 50 mm) and sets the zero point on the base

plate.

Note: Once the zero point has been accepted, confirmation is given by

a twofold optical (LED) and acoustic signal (beep).

After the reference point has been confirmed, any zero point can be

selected.

2.4

Calibrating a probe

a)

Press the calibrate probe key

b)

Press the function key „Calibrate in a groove“, the probe moves

automatically to the center of the groove of the setting standard.

c)

Slide the setting standard, so that the probe is within the groove.

The groove will be automatically measured for a second time.

d)

The determined probe constant will be displayed.

Description / Sequence

Symbols / Pictures

Note:

The determined probe constant is always slightly smaller than the

actual diameter of the probe (please refer to 4.1).

a)

b)

c)

d)

2

1