Mahr Digimar 817 CLM Operating Instructions Manual - page 35
Manual is about: quick height
of
152
35
Mahr GmbH • Digimar 817 CLM
Description / Sequence
Symbols / Pictures
3.3.4
Measuring a bore
Note: „Measuring a bore“ must be active.
See chapter 3.3.3
–
Position the probe into the bore, the probe must be off-set
–
To start measurement, briefly press the speed key.
<0.5 s
contact
from below
(upwards)
<0.5 s
contact
from above
(downwards)
3.4
Abort a measurement:
Should a measurement have been inadvertently started, simply press a
speed key or the cancel key, this is sufficient to abort the measurement.