D-Link DES-3624 - Switch - Stackable User manual - page 101
Stackable NWay Ethernet Switch User’s Guide
Figure 6-17. STP Parameter Setting screen
3. Change the Disabled setting to Enabled in the Spanning
Tree Protocol field.
4. Enter the Bridge Max Age in the Max Age(6-40 sec) field.
5. Enter the Bridge Hello Time in the Hello Time(1-10 sec)
field.
6. Enter the Bridge Forward Delay time in the Forward
Delay(4-30 sec) field.
7. Enter the Bridge Priority in the Bridge Priority(0-65535)
field.
The information on the screen is described as follows:
♦ Spanning Tree Protocol Select Enabled to implement
the Spanning Tree Protocol.
♦ Time Since Topology Change(Sec) Read-only object
displays the last time changes were made to the
network topology. These changes usually occur when
backup paths are activated due to primary path
failures.
♦ Topology Change Count Read-only object displays
the number of times (since the current management
session with the device was started) changes were
made to the network topology. Changes usually occur
on the network when backup paths are activated.
♦ Designated Root Read-only object displays the MAC
(Ethernet) address of the bridge/switch on the network
that has been chosen as the STP root.
Using the Console Interface
81